Dell S4112F EMC S4112–ON Series Installation Guide October 2021 - Page 19

4 S4112-ON Series installation To install the S4112-ON Series (S4112F-ON and S4112T-ON) switch, complete the installation procedures in the order presented in this section. Always handle the switch and its components with care. Avoid dropping the switch or any field replaceable units (FRUs). NOTE: ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel ground strap when handling the S4112-ON Series switch and its components. As with all electrical devices of this type, take all the necessary safety precautions to prevent injury when installing this switch. NOTE: For more information, see the Open Networking Hardware Diagnostic Guide. Topics: • Unpack • Ground cable • Rack or cabinet installation • Half RU front-rack installation • Switch installation • Optics installation • Switch power-up • After switch installation • Switch replacement Unpack NOTE: Before unpacking the switch, inspect the container and immediately report any evidence of damage. When unpacking the S4112-ON Series switch, make sure that the following items are included: ● One S4112F-ON or S4112T-ON switch ● One RJ-45 to DB-9 female cable ● AC power: two country- and region-specific AC power cables ● Two AC power cable clips ● DC power: two DC connectors ● AC ground lug kit ● DC ground lug kit-included in the accessories box ● S4112-ON Series Set-up Guide ● Safety and Regulatory Information ● Warranty and Support Information Unpack steps 1. Place the container on a clean, flat surface and cut all straps securing the container. 2. Open the container or remove the container top. 3. Carefully remove the switch from the container and place it on a secure and clean surface. 4. Remove all packing material. 5. Inspect the product and accessories for damage. S4112-ON Series installation 19