Dell S5148F-ON EMC Networking OS10 Enterprise Edition Switch Configuration Gui - Page 22

Note: Default spanning tree settings are used in this deployment. In OS10EE, RVPST+ is enabled by default, and RPVST+ VLAN priority numbers start at 32769. Modify the spanning tree settings if required for your environment. LLDP is enabled on each interface and globally by default. LLDP is useful for troubleshooting and validation. Dell EMC recommends leaving it enabled. General settings - dual switch with VLT S5148F-Leaf1A configure terminal S5148F-Leaf1B configure terminal hostname S5148F-Leaf1A hostname S5148F-Leaf1B interface mgmt1/1/1 no ip address ip address 100.67.172.38/24 no shutdown management route 0.0.0.0/0 100.67.172.254 interface mgmt1/1/1 no ip address ip address 100.67.172.37/24 no shutdown management route 0.0.0.0/0 100.67.172.254 ntp server 100.67.10.20 ntp server 100.67.10.20 7.1.2 Configure VLANs In this section, VLANs are configured per Table 2. Create the in-band management VLAN and assign a unique IP address on each switch. Configure VRRP to provide gateway redundancy. Set the VRRP priority. The switch with the largest priority value becomes the master VRRP router. Assign the same virtual address to both switches. Create the vMotion, vSAN, and VM Network VLANs. Configure VLANs - dual switch with VLT S5148F-Leaf1A S5148F-Leaf1B interface vlan1611 description InBand_Mgmt ip address 172.16.11.253/24 vrrp-group 11 priority 150 virtual-address 172.16.11.254 no shutdown interface vlan1611 description InBand_Mgmt ip address 172.16.11.252/24 vrrp-group 11 priority 100 virtual-address 172.16.11.254 no shutdown interface vlan1612 description vMotion no shutdown interface vlan1612 description vMotion no shutdown interface vlan1613 description vSAN no shutdown interface vlan1613 description vSAN no shutdown interface vlan1614 description VM_Network_A no shutdown interface vlan1614 description VM_Network_A no shutdown 22 Dell EMC Networking OS10 Enterprise Edition Switch Configuration Guide for VxRail 4.5