Dell Vostro 500 Owner's Manual - Page 122
Internal Card With Bluetooth, Wireless, Technology
View all Dell Vostro 500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
Replacing Mini-Card NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors on the card and on the system board, and realign the card. NOTICE: To avoid damage to the Mini-card, never place cables under the card. 1 Insert the card connector into the system board connector at a 45-degree angle. 2 Press the other end of the card down into the slot on the system board until the card clicks into place. 3 Replace the securing screw. 4 Connect the cables to the Mini-Card, ensuring that you route the cables correctly. NOTE: For more specific information about which cable to connect to which connector, see the documentation that came with your Mini-Card. 5 Secure unused antenna cables in the protective mylar sleeve. 6 Replace the cover and tighten the eight captive screws. Internal Card With Bluetooth® Wireless Technology CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide. NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on the back of the computer). NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the computer. If you ordered a card with Bluetooth wireless technology with your computer, it is already installed. Removing the Card 1 Follow the procedures in "Before You Begin" on page 107. 2 Remove the hinge cover (see "Hinge Cover" on page 113). 3 Remove the screw securing the card. 122 Adding and Replacing Parts