Denon 2310CI Owners Manual - Page 30
Denon 2310CI - AVR AV Receiver Manual
UPC - 883795000918
View all Denon 2310CI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
ENGLISH Making the Optimum Settings for the Connected Speakers Automatically (Audyssey™ Auto Setup) Getting Started Connections Settings Playback Multi-Zone Remote Control Information Troubleshooting Specifications Check Check Check Check cause AUTO cause AUTO Front R Retry cause AUTO Front L Retry Skip ENTER cause of problem! Enter RETURN Cancel Error Messages If "Audyssey Auto Setup" could not be completed due to speaker installation, the measuring environment, etc., an error message is displayed. If this happens, check the relevant items, be sure to take the necessary measures, then perform "Audyssey Auto Setup" over again. Check Audyssey Auto Setup Measurement Results (Parameter Check) This is displayed after "Audyssey Auto Setup" is completed. NOTE Be sure to turn the power off before checking the speaker connections. Error messages (examples) AUTO SETUP AUTO SETUP Caution! No microphone or Speaker MultEQ AUDYSSEY Cause • Included setup microphone is not connected. • Not all speakers could be detected. • The front L speaker was not properly detected. Measures • Connect the included setup microphone to the SETUP MIC jack on the main unit. • Check the speaker connections. Press ui to select 1 "Parameter Check", AUTO SETUP CHECK PARAMETER then press p or . Speaker Distance Channel EQ Check Config Check Level Check Check Check Crossover Restore Show Retry speaker configuration result RETURN of problem! Cancel Front • Too much noise in the room for accurate measurements to be made. • Speaker or subwoofer sound is too low for accurate measurements to be made. • Either turn off any device generating noise or move it away. • Try again when the surroundings are quieter. • Check the speaker installation and the direction in which the speakers are facing. • Adjust the subwoofer's volume. SETUP AUTO SETUP Caution! Ambient or Level noise is is too low high too MultEQ AUDYSSEY Retry ui to select the item you want to check, then 2 Use press p or . Speaker Config. Check : Check the speaker configuration Distance Check : Check the distance : Check the channel level : Check the equalizer RETURN of problem! Cancel SETUP AUTO SETUP MultEQ AUDYSSEY Caution! None ENTER of problem! Enter RETURN Cancel • Displayed speaker could not be detected. · The front R speaker were not properly detected. · Only one channel of the surround speakers was detected. · Sound was output from the R channel when only one surround back speaker was connected. · The surround back, but the surround speaker was not detected. • Displayed speaker connected with the polarities reversed. • Check the speaker. connections of the displayed Channel Level Check EQ Check Crossover Freq. Check : Check the crossover frequency SETUP AUTO SETUP MultEQ AUDYSSEY Caution! Phase • Check the polarities of the displayed speaker. • For some speakers, this error message may be displayed even if the speaker is properly connected. If you are sure that the wiring is correct, press ui to select "Skip" , then press . o p to switch the display between the different 3 Use speakers. 4 Press . The confirmation screen reappears. Repeat steps 2 and 3. Even if the settings are changed after "Audyssey Auto Setup" , Audyssey Auto Setup settings can be restored by selecting "Restore" then pressing . n To perform "Audyssey Auto Setup" again Press ui to select "Retry" , then press . n To cancel Audyssey Auto Setup Press , the "Cancel auto setup?" prompt is displayed. Press o p and select "Yes", then press . 26 Remote control operation buttons Displaying the menu : Cancel the menu : Moves the cursor (Up/Down/Left/Right) : Decision the setting : Return to previous menu