Denon 2310CI Owners Manual - Page 56

ENGLISH Convenient functions HDMI Control Function When you make an HDMI connection with a TV or player compatible with AVR-2310 and HDMI control functions, you can perform the following operations by setting the HDMI control function of each device. Getting Started Connections Settings Playback Multi-Zone Remote Control Information Troubleshooting Specifications n AVR-2310 power off can be linked to the TV power off step z When you set "Output audio from amp" in the TV audio output setup operation, you can switch the amp power on. 1 2 3 4 5 Turn the power on for all the equipment connected by HDMI cable. connected by HDMI cable. Set "HDMI Control" (vpage 30) to "ON" . Setting the Power to Standby After a Certain Amount of Time (Sleep Timer Function) This function allows you to automatically set the power to standby after the set amount of time has passed. When the sleep timer turns the power off in the MAIN ZONE, the power also turns off in the ZONE2. Set the HDMI control function for all equipment n You can switch audio output devices with a TV operation b Please refer to the owner's manual as regards setting of connected devices. b Carry out Steps 1 and 2 should any of the equipment be unplugged. Press and display the time you want to set. is Switch the television input to the HDMI connected to The "SLEEP" indicator on the display lights. • The time switches as shown below each time pressed. Sleep:OFF Sleep:30min Sleep:120min Sleep:90min n You can adjust AVR-2310 volume in the TV volume adjustment operation the AVR-2310. and check if the picture from the player is ok. the power of the AVR-2310 and player also goes on standby. Sleep:60min n You can switch AVR-2310 input source through linkage to TV input switching Switch the AVR-2310 input to the HDMI input source When you turn the TV's power to standby, check that n When playing the player, the AVR-2310 input function switches to the function of that player • The time display turns off after about 5 seconds, and the setting is activated. • Once the set time has passed, the power is automatically set to standby. n To cancel the sleep timer Press to set "OFF" . • The "SLEEP" indicator on the display turns off. Rear • To play the TV's sound on the AVR-2310, make optical digital connections (vpage 13 "Connecting the Monitor (TV)"). • To use this function, set "HDMI Control" (vpage 30) to "ON". NOTE • When you power off AVR-2310, the HDMI control function does not operate. • Some functions may not operate depending on the connected TV or player. Check the owner's manual of each device for details beforehand. • When "HDMI Control" is set to "ON", it is not possible to assign an HDMI terminal to "TV" at "HDMI" (vpage 30). • When "HDMI Control" (vpage 30) is set to "ON" , power is supplied constantly to the AC outlet (UNSWITCHED). If the HDMI control function does not operate properly, check the following points. • Is the TV or player compatible with the HDMI control function? • Is the AVR-2310 properly set? • Is "HDMI Control" (vpage 30) set to "ON"? • Is "Power Off Control" (vpage 30) set to "ON"? • Are the HDMI control function settings of all equipment correct? NOTE Should any of the operations below be performed, the interlocking function may be reset, in which case, repeat step's 1 and 2. • Menu "HDMI" (vpage 30) setting has changed. • There is a change to the connection between the equipment and the HDMI, or an increase in equipment. 2