Denon S-5BD Owners Manual - English - Page 12
Calculation, Check, Store
UPC - 083795001216
View all Denon S-5BD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Getting Started Simple Version Connections Playback (Basic) Settings Playback (Advanced) ENGLISH Set Up Speakers (Audyssey™ Auto Setup) STEP 4 Calculation STEP 5 Check STEP 6 Store 9 On the STEP3 screen, select "Next → Calculation", and then press ENTER. Measuring results are analyzed, and the frequency response of each speaker in the listening room is determined. FIRST SETUP 2/2 STEP4 Calculation Now calculating... Please wait. 20% 1 2 3 4 5 6 • Analysis takes several minutes to complete. The time required for this analysis depends on the number of speakers connected. The more connected speakers there are, the longer it takes to perform analysis. 10 Select the item you want to check, and then press ENTER. FIRST SETUP 2/2 STEP5 Check Check processing results. To proceed, press "Next". Spkr Config Check Distance Check Ch. Level Check Crossover Check Next Store Select item to check Enter 1 2 3 4 5 6 RETURN Cancel • Subwoofers may measure a greater reported distance than the actual distance due to added electrical delay common in subwoofers. • If you want to check another item, press RETURN. 11 Select "Next → Store" and then press ENTER. 12 Press ENTER. Save the measuring results. 14 Set Dynamic Volume. FIRST SETUP 2/2 STEP6 Store Press "Store" to store calculation results. 1 2 3 4 5 6 Store Enter Apply and store measurement result RETURN Cancel • The save operation takes about 30 seconds to complete. NOTE During saving of measuring results, be sure not to turn off the power. 13 When the following screen is displayed, unplug the setup microphone from the unit's SETUP MIC jack. FIRST SETUP 2/2 Finish Storing complete. Auto Setup is now finished. Please unplug microphone. Turn on Dynamic Volume? Yes No Enter Do not use "Dynamic Volume". 1 2 3 4 5 6 FIRST SETUP 2/2 Finish Storing complete. Auto Setup is now finished. Please unplug microphone. Turn on Dynamic Volume? Yes No 1 2 3 4 5 6 Use "Dynamic Volume". Enter • For details of Dynamic Volume settings, see page 52. n When turning Dynamic Volume on • Select "Yes", and then press ENTER. This completes speaker setup. n When turning Dynamic Volume off • Select "No", and then press ENTER. The MultEQ default settings are displayed. • Press ENTER to exit. FIRST SETUP 2/2 CD BD/DVD FM/AM HDMI1/2/3 USB AUX1/2 MultEQ : OFF MultEQ : ON MultEQ : OFF MultEQ : ON MultEQ : OFF MultEQ : ON Exit Shows information about current settings • For details of MultEQ settings, see page 51. NOTE After performing Audyssey Auto Setup, do not change the speaker connections or subwoofer volume. In event of a change, perform Audyssey Auto Setup again. Multizone GUI Remote Control Part Names Other Information Troubleshooting Spec. Index Remote control operation buttons Move the cursor (Up/Down/Left/Right) Confirm the setting Return to previous menu