Denon S-5BD Owners Manual - English - Page 13

Getting Started Simple Version Connections Playback (Basic) Error Messages An error message is displayed if Audyssey™ Auto Setup could not be completed due to speaker placement, the measurement environment, etc. If this happens, check the relevant items, be sure to take the necessary measures, then perform Audyssey Auto Setup over again. NOTE Be sure to turn off the power before checking speaker connections. Examples Caution! No microphone or speaker Caution! Ambinet noise is too high or Level is too low Error details Measures • The connected setup microphone is broken, or a • Connect the included setup microphone to the device other than the supplied setup microphone SETUP MIC jack of this unit. is connected. • Not all speakers could be detected. • Check the speaker connections. • The front L speaker was not properly detected. • There is too much noise in the room for accurate • Either turn off any device generating noise or move measurements to be made. it away. • Perform again when the surroundings are quieter. • Speaker or subwoofer sound is too low for accurate • Check the speaker installation and the direction in measurements to be made. which the speakers are facing. • Adjust the subwoofer's volume. Caution! • The displayed speaker could not be detected. • Check the connections of the displayed speaker. Front R None Caution! Front L Phase • The displayed is connected with the polarities • Check the polarities of the displayed speaker. reversed. • For some speakers, this error message may be displayed even if the speaker is properly connected. If you are sure the connection is correct, press ui to select "Skip", then press ENTER. ENGLISH Settings Playback (Advanced) Multizone GUI Remote Control Part Names Other Information Troubleshooting Spec. Index