EMC CX400 Installation Guide - Page 107

HP-UX Installation Checklist Task With Access Logix Reference Document 7 Storage System ❑ Use the following Navisphere CLI commands to set the default failover Set properties mode and array commpath properties with the following commands: Navisphere CLI reference navicli -h hostname failovermode 0 navicli -h hostname arraycommpath 1 where hostname is the IP address or network name of an SP in the storage system. 8 Storage System ❑ Use Navisphere Manager to set general storage-system properties. Configure ❑ Use Navisphere Manager to create RAID Groups, bind LUNs, create Storage Groups, and assign LUNs to Storage Groups. Navisphere Manager administrator's guide and online help ❑ Use Navisphere Manager to connect the server to a Storage Group. 9 Server Make LUNs visible ❑ Log in as root and restart the Navisphere Host Agent with the following HP-UX commands: /sbin/init.d/agent stop /sbin/init.d/agent start CX-Series Server Software for HP-UX Installation Guide ❑ Checkpoint - Verify that HP-UX can recognize these LUNs with the following HP-UX commands: ioscan -fnC disk insf -e If HP-UX does not recognize any LUNs, verify the connection to the Storage Group. HP-UX documentation ❑ Verify that HP-UX sees device entries for all LUNS with the following HP-UX command: ioscan -fnC disk If you do not see two paths to each LUN, verify that the OptionsSupported Autotrespass entry in the Host Agent configuration file is uncommented or commented as described in step 5. 10 Storage System ❑ Plan your monitoring configuration. Navisphere Manager Set up Event Monitor administrator's guide ❑ Use Navisphere Manager to set user options, create templates, and set up and online help your monitoring configuration. Without EMC Failover Software Checklist - New HP-UX Server and New Storage System 2-57