EMC CX400 Installation Guide - Page 43

AIX Installation Checklists Task With Access Logix Without Access Logix Reference Document 9 Storage System For new or replacement HBAs For any HBAs Navisphere CLI Set properties for ❑ Use the following Navisphere CLI ❑ Use the following Navisphere CLI reference PowerPath command to determine the command to determine the default storage-system type: default storage-system type: ❑ Use the following Navisphere CLI commands to set the following storage-system properties for the server's new or replacement HBA ports (initiators): navicli -h hostname storagegroup -sethost -host servername -type 3 navicli -h hostname storagegroup -sethost -host servername -failovermode 1 navicli -h hostname storagegroup -setpath -host servername -arraycommpath 1 navicli -h hostname systemtype where hostname is the IP address or network name of an SP in the storage system. If the default storage-system system type is not 3 (CLARiiON Open), use the following Navisphere CLI command to set it to 3: navicli -h hostname systemtype -config 3 CAUTION The above command reboots both SPs at the same time. where hostname is the IP address or network name of an SP in the storage system servername is the server's name or network address Note: Setting the array commpath property to 1 (enabled) creates LUNZ devices. You will have to remove the LUNZ devices later in the procedure. PowerPath Checklist - Existing AIX Server and Existing Storage System 1-33