EMC CX400 Installation Guide - Page 18
With Access Logix, Reference Document - san storage
View all EMC CX400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
AIX Installation Checklists Task With Access Logix Reference Document 9 Storage System ❑ Install the Navisphere Initialization Utility on a non-AIX host on the same Storage-system setup Initialize and subnet as the storage-system management ports. guide install software enablers ❑ Use the Navisphere Initialization Utility to initialize the storage system. ❑ If you have SAN Copy, SnapView, and/or MirrorView software, install their Navisphere Manager enablers. administrator's guide and online help 10 Storage System ❑ Connect the storage system to the switch or HBA ports. Cable Storage-system setup guide. ❑ Checkpoint - For a SAN, verify the storage-system connections to the switch by checking the LED(s) for the switch port connected to each SP port. Switch documentation For a 1-Gbit switch - LED is green, which indicates that the SP is logged in to the switch port. For a 2-Gbit switch - One of the following: • The left LED is green and the right LED is off, which indicates that a 1-Gbit SP port is logged in to the switch port. • For a DS-xxB2 switch, both LEDs are green, which indicates that a 2-Gbit HBA port is logged in to the switch port. • For a DS-xxM2 switch, the left LED is blue and the right LED is off, which indicates that a 2-Gbit HBA port is logged in to the switch port. ❑ Cable each SP to the LAN connected to the hosts from which you will manage the storage system. Storage-system setup guide. 11 Storage System ❑ Use Navisphere Manager to define a global administrator and domain (if Set up security not already defined) and any additional users. Navisphere security administrator's guide and Navisphere Manager online help 12 Storage System ❑ Use the following Navisphere CLI commands to set the storage system's Set properties default system type, failover mode, and array commpath values: for PowerPath navicli -h hostname systemtype -config 3 Navisphere CLI reference navicli -h hostname failovermode 1 navicli -h hostname arraycommpath 1 where hostname is the IP address or network name of an SP in the storage system. Note: Setting the array commpath property to 1 (enabled) creates LUNZ devices. where hostname is the IP address or network name of an SP in the storage system. 1-8 EMC Installation Roadmap for CX-Series and FC-Series Storage Systems