Edimax EW-7228APn Manual - Page 84
Wireless Advanced - firmware upgrade
View all Edimax EW-7228APn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
I can't locate the access point with my wireless client. File transfers are slow or frequently interrupted. I can't log onto the browser-based configuration interface: incorrect password. The access point is extremely hot. filter, try to connect the access point to another computer. e. Set your computer to obtain an IP address automatically (DHCP), and see if your computer can obtain an IP address. f. If you are experiencing problems after a firmware upgrade, please contact your dealer of purchase for help. a. Check if "Broadcast ESSID" (in the "Wireless Advanced" section of the browser-based configuration interface) is "Enabled" or "Disabled". If "Disabled" you need to input the ESSID into your wireless client manually. b. Try moving closer to the access point a. Try to move closer to where the wireless access point is located. b. Try again later. Your local network may be experiencing technical difficulties or very high usage. c. Change channel number. a. Password is case-sensitive. Make sure the "Caps Lock" light is not illuminated. b. If you do not know your password, restore the device to factory settings. a. It is normal for the access point to heat up during frequent use. If you can safely place your hand on the access point, the temperature of the device is at a normal level. b. If you smell burning or see smoke coming from access point or A/C power adapter, then disconnect the access point and A/C power adapter immediately, as far as it is safely possible to do so. Call your dealer of purchase for help. 84