Electrolux EI30EF4CQS Complete Owner's Guide (English) - Page 10
Luxury Glide, oven racks, Arranging Regular Racks, IMPORTANT
View all Electrolux EI30EF4CQS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
10 Oven Cooking Luxury GlideTM oven racks IMPORTANT Luxury-GlideTM extendable oven rack upper rack portion Remove ALL oven racks before starting a fresh clean cycle. If oven racks are left inside the oven during a cleaning cycle, the slide ability of the Luxury-GlideTM oven racks may be damaged and all of the oven racks will lose their shiny finish. Clean oven racks according to the instructions provided in the Care & Cleaning section. The fully extendable Luxury-GlideTM rack makes food preparation easier. This oven rack has glide tracks that allow the rack to be pulled away from the oven without rubbing the sides of the oven wall. Removing and replacing the LuxuryGlideTM oven racks To remove - Using one hand, reach through handle opening and lift up on the release level located across the lower front of the rack as shown in Figure 1. While holding up the release lever, pull the glide rack out of the oven until the stop position is reached (see Figure 2). Using both hands, grasp the upper and lower portions of the glide rack. Lift up the front of the rack slightly and continue to pull the rack away from the oven (see Figure 3). Be sure to grasp both upper and lower rack portions together when removing or handling the glide rack. The rack portions move independently and are difficult to handle unless held together. To replace - grasp both upper and lower portions of glide rack, lift and hold the rack level between the oven cavity walls. Tilt the front of the rack upward slightly and slide the rack completely into position. Some force may be necessary to make sure the oven rack has snapped completely into place. IMPORTANT release lever Fig. 1 lower rack portion Fig. 2 Fig. 3 To prevent possible damage to the oven, DO NOT attempt to close the oven door until all the oven racks are fully positioned back inside the oven cavity. Arranging Regular Racks To remove an oven rack, pull the rack forward until it stops. Lift up front of rack and slide out (fig. 4). To replace an oven rack, fit the rack onto the guides on the oven walls. Tilt the front of the rack upward and slide the rack back into place. Fig. 4