Electrolux EI30EF4CQS Complete Owner's Guide (English) - Page 37

Care and Cleaning 37 Special door care instructions Changing oven lights IMPORTANT Most oven doors contain glass that can break. Read the following recommendations: • Do not close the oven door until all the interior oven racks are fully inserted and retracted to the back of the oven. • Do not hit the glass with pots, pans, or any other object. The oven door glass may break or even break at a later time unexpectedly. • Scratching, hitting, jarring or stressing the oven door glass may weaken its structure causing an increased risk of breakage at a later time. • You may use a glass cleaner on the outside of the oven door glass. Do not spray or allow water or the cleaner to enter or drip down into the oven door vents. Spray cleaner on cloth first and then wipe the oven door clean. • Do not use strong oven cleaners, powders or any harsh abrasive cleaning materials on the outside of the oven door or glass. • Never clean the oven door gasket. The oven door gasket should always clean during the Self-clean cycle. Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a leather-faced glove for protection against possible broken glass or burns. The oven lights will automatically turn ON when the oven door is opened. The oven lights may also be manually operated by pressing the pad. The oven light bulb is covered with a glass shield. The glass shield can be removed to be cleaned manually or to change oven light. THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE. To replace the light bulb: Replacing the Round Halogen Oven Light: 1. Turn the power off at the main source or unplug the appliance. 2. The bulb is covered with a glass shield screwed in place (fig. 1). Replace bulb with 25-watt halogen appliance bulb only (fig. 2). Please note: do not allow your fingers to touch the new bulb when replacing. This will shorten the life of the new bulb. Use a paper towel to cover the new bulb when installing. 3. Replace the glass shield (fig.1). The glass shield must be in place whenever the oven is in use. 4. Turn power back on again at the main source (or plug the appliance back in). Figure 1 - Glass shield 5. The clock will then removal need to be reset. Figure 2 - Pull bulb out.