Electrolux EI30IF40LS Complete Owner's Guide (English) - Page 38
Setting fresh clean cont'd, Starting fresh clean after cancelling, Setting delayed fresh clean
View all Electrolux EI30IF40LS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
38 Setting Oven Controls Setting fresh clean (cont'd) To cancel self-clean: 1. Press . CANCEL 2. If the self-clean cycle has heated the oven to a high enough temperature, Hot (Figure 72) will appear in the display. Allow enough time for the oven to cool and for the door OPn message to display (Figure 73). When this message turns OFF the oven door may be opened. Setting delayed fresh clean You may wish to set the oven to perform a self-clean at a later time (up to 12 hours later). The end time key will determine when the cleaning will stop. The end time must be set far enough from the real time to allow for the type of clean cycle you select, whether 2, 3, or 4 hours. Remember to add 30 to 40 additional minutes of cooling time before using the oven for cooking. Setting for a heavy (4 hour) self clean cycle to end at 8:00 o'clock: Fig. 72 Oven too hot for door to unlock Fig. 73 Door opens when oven cools enough Starting fresh clean after cancelling: If a self clean cycle was cancelled using the cancel key before the oven was finished cleaning, you may wish to set another self-clean cycle. If self clean was cancelled shortly after being started, and the oven interior did not reach high self-clean temperatures, the next clean cycle may be set as soon as the oven door unlocks from the cancelled clean cycle. If the oven reached high temperatures before the self-clean cycle was cancelled, you may be required to wait up to 4 hours before the control will allow another self-clean cycle to be started. Restarting a fresh clean cycle after a power outage: If the self-clean cycle was interrupted by a power failure, the oven may not be thoroughly cleaned. Another self-clean cycle may be needed. Once power is restored, the oven has cooled and the door unlocks, set to clean for another cycle. Setting repeated self-clean cycles If attempting to set repeating self-clean cycles, the control may display the message CLEAn then dELAy followed by the length of time before the next self-clean may be set. For example, if the message display reads "4:00" and the time is 12:00 o'clock, the control will not allow a self-clean to be set until after 4:00 o'clock. 1. Be sure the clock is set with the correct time of day. In this example the time of day should be earlier than 4:00 o'clock. Remove all oven racks. Remove all items from the cooktop. Be sure the oven door is completely closed. 2. Press end time 3. Enter 8 0 0 using the numeric keypad 4. Press START end time 800 5. Press fresh clean 6. Press fresh clean again 7. Press START START fresh clean fresh clean START Press CANCEL at any time to stop fresh clean To avoid possible burns use caution opening the oven door after the self-clean cycle is finished. The oven may still be VERY HOT. Stand to the side of the oven when opening the door to allow hot air to escape.