Epson PP-50BD Users Guide for Mac - Page 61
Loading Discs, For PP-100II/PP-100/PP-100AP
View all Epson PP-50BD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Publishing Discs Loading Discs This section describes how to load discs into the input stacker, and insert it. Load the discs into a stacker. Do not load discs in the drives or printer. Furthermore, with the PP-100II or PP-100, do not load discs between Drive 1 and Drive 2. They may become unable to be removed. 1 Fully separate the discs to prevent them from sticking together. • Be sufficiently careful not to scratch a disc. • If a long time elapses after discs are loaded in the stacker, the separated discs may stick together again. Fan the discs again if a long time has elapsed since they were loaded. 2 Open the disc cover. For precautions when you open the disc cover, see "Opening the Disc Cover" on page 21. 3 Take out the input stacker and load the discs into it. Place the label surface facing upwards. • Do not load discs above the red line on the stacker. The product may malfunction, or the discs may be damaged. • Make sure that the bottom of the stacker is not dirty before loading the discs. The stacker to use as the input stacker differs depending on the product model and the set publish mode. Confirm the input stacker in the following table. For PP-100II/PP-100/PP-100AP Publish Mode Input Stacker Standard Mode Stacker 1 External Output Mode (Different types of discs can be loaded into Stacker 1 and Stacker 2.) Stacker 1 Stacker 2 Batch Mode Stacker 1 Stacker 2 Number of Discs Up to approximately 50 discs Up to approximately 50 discs Up to approximately 50 discs Up to approximately 50 discs Up to approximately 50 discs 61