Epson PP-50BD Users Guide for Mac - Page 71
Taking out discs, For PP-100II/PP-100/PP-100AP
View all Epson PP-50BD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Publishing Discs Taking out discs When the publishing process finishes, follow the steps below to take out published discs. For PP-100II/PP-100/PP-100AP The stacker used as the output stacker differs depending on the publish mode. Confirm the output stacker in the following table. Publish Mode Standard mode (when the output stacker is set to Stacker 2) Standard mode (when the output stacker is set to Stacker 4) External Output mode (when the output stacker is set to Stacker 3) External Output mode (when the output stacker is set to Stacker 4) Batch mode Output Stacker Number of Discs Stacker 2 Up to approximately 50 discs Stacker 4 Up to approximately 5 discs Stacker 3 Up to approximately 50 discs Stacker 4 Stacker 2 Stacker 3 Up to approximately 5 discs Up to approximately 50 discs Up to approximately 50 discs 1 Only when the output stacker is Stacker 2 or Stacker 3, open the disc cover and take it out. For precautions when you open the disc cover, see "Opening the Disc Cover" on page 21. 2 Take out the published discs from the stacker. • After printing on the label surface, allow EPSON specified CDs/DVDs to dry for at least one hour, and other types of discs for at least 24 hours. Do not insert discs into a drive or other device until they are completely dry. • Avoid drying under direct sunlight. • Directly touching or moisture getting on the label surface before or after printing may result in blurring or discs sticking together. 71