Epson TM-m30II Technical Reference Guide TM-m30II-N - Page 106

Printing and Cutting Positions Appendix Manualcutter position Autocutter position Approx. 9.5 mm {0.37"} Approx. 20.0 mm {0.79"} Center of the print dotline Paper feed direction • The values above may vary slightly as a result of paper slack or variations in the paper. Take this into account when setting the cutting position of the autocutter. • When removing cut paper, the remaining roll paper is pulled at the uncut section and the pitch of the next print may be reduced. When printing after cutting paper for prints with no pitch reduction, feed the paper about 1 mm {16/406 inches} before printing. When the Pre-feed before next print function is enabled, this operation is performed automatically. See"Software Settings" on page 48 for more details. Electrical Characteristics Operating voltage Current consumption (24V, 25°C, standard print density) Standby Operating DC 24V ± 7% Mean: 0.1 A Mean: 1.8 A* *: When charging at 2.1A Note: When print ratio is approximately 18% • Continuous printing for 50 lines (repeating 20H-7FH) ∗ Font A, 35 columns, ASCII character • 5 lines feeding • Autocutting 106