Epson TM-m30II Technical Reference Guide TM-m30II-N - Page 43
Setup, Wireless LAN Cable Set, Firmware Version, OT-WL02, 03A ESC/POS or later
![]() |
View all Epson TM-m30II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Chapter 2 Setup • When using wireless LAN, make sure you disconnect the LAN cable. If a LAN cable is connected, wireless LAN is disabled. • The combinations of wireless LAN cable set and firmware version you can use with this product are as follows. Wireless LAN Cable Set OT-WL02 OT-WL05 OT-WL06 Firmware Version 3.03A ESC/POS or later 3.03B ESC/POS or later 3.03A ESC/POS or later 3.03B ESC/POS or later You can perform a firmware update by using the TM-m30II Firmware Updater if using a Windows computer, or by using the Epson TM Utility if using a smart device. For details, see "Utilities" on page 84. • When you set up the access point at the same time, set the access point in advance and check that it operates correctly. • Examine the radio wave situation in the surrounding area before use. • Avoid using the same channel that is used in the neighboring shops where Wireless LAN is used. • When using the printer in environments where kitchen microwaves and other devices that may interfere radio waves are installed, observe the following points. * Keep the printer away from the devices, such as kitchen microwaves, that may cause radio wave interference. * Use channels that are away from the frequency bands that may cause radio wave interference. * Place shields between the printer and the devices that may cause radio wave interference. * Select either 2.4 GHz or 5 GHz, whichever is free from radio wave interference. * In auto channel setting for the access point, do not select a channel in which the devices may cause radio wave interference. • In the infrastructure mode, W53 and W56 channels are not available to connect to a stealth SSID access point. 43
![](/manual_guide/products/epson-tmm30ii-technical-reference-guide-tmm30iin-a7c3948/43.png)