Gateway NX100 Gateway Notebook Reference Guide R2 for Windows XP - Page 49
Changing batteries, Replacing the battery
View all Gateway NX100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Changing batteries Changing batteries Replacing the battery Warning Danger of explosion if battery is incorrectly replaced. Replace only with a battery specifically manufactured for your Gateway notebook. Discard used batteries according to local hazardous material regulations. The battery used in this device may present a fire or chemical burn hazard if mishandled. Do not disassemble, heat above 212°F (100°C), or incinerate. Dispose of used battery promptly. Keep away from children. Caution If your notebook is connected to an AC outlet, you can change the battery while the notebook is turned on. If your notebook is not plugged into an AC outlet, you must turn the notebook off while changing the battery or you will lose any unsaved data. To replace the battery: 1 If your notebook is on and is connected directly to AC power, go to Step 2. -OR- If your notebook is on and is not plugged into an AC outlet, save your work and turn off the notebook. 2 Close the LCD panel. 3 Turn your notebook over so the bottom is facing up. 4 Press in the small square button on the battery release latch, slide the latch in the direction shown, then slide the battery out of your notebook. . 5 Slide a recharged battery into your notebook until it snaps into place. 6 Slide the battery lock to the locked position. 7 Turn your notebook over. 8 Open the LCD panel and press the power button. 43