Haier QFD15ESSNWW Installation Instructions - Page 13
Mobile Or Manufactured Home, Installation, Requirements For Alcove Or, Closet Installation, Minimum
View all Haier QFD15ESSNWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ENGLISH INSTALLATION INSTRUCTIONS REQUIREMENTS FOR ALCOVE OR CLOSET INSTALLATION WARNING - Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from dryer. Place dryer at least 18" (46 cm) above the floor for a garage installation. Failure to do so can result in death, explosion, or fire. • The dryer MUST be vented to the outdoors. • Minimum clearance between dryer cabinet and adjacent walls or other surfaces is: 0" either side 1" front and rear 1" top • The rear of the dryer should face a wall. • Consideration must be given to provide adequate clearance for installation and service. • Closet doors must be louvered or otherwise ventilated and have at least 60 square inches of open area. If the closet contains both a washer and a dryer, doors must contain a minimum of 120 square inches of open area. NOTE: WHEN THE EXHAUST DUCT IS LOCATED AT THE REAR OF THE DRYER, THE CONFIGURATION OF THE DUCTING MAY REQUIRE GREATER THAN 3" OF REAR CLEARANCE. MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET INSTALLATION Minimum clearance to combustible surfaces and for air opening are: 0" both sides, 1" rear and 1" top. The rear of the dryer should face a wall. Consideration must be given to provide adequate clearance for installation and service. MOBILE OR MANUFACTURED HOME INSTALLATION • Installation MUST conform to the MANUFACTURED HOME CONSTRUCTION AND SAFETY STANDARD, TITLE 24, PART 3280 or STANDARD FOR MOBILE HOMES CAN/CSA-Z240 MH, or, when such standards are not applicable, with AMERICAN NATIONAL STANDARD FOR MOBILE HOME, ANSI/ NFPA NO. 501B. • The dryer MUST be vented to the outdoors. • The exhaust vent MUST be securely fastened to a non-combustible portion of the mobile home. • The vent MUST NOT be terminated beneath a mobile or manufactured home. • The vent duct material MUST BE METAL. • KIT 14-D346-33 MUST be used to attach the dryer securely to the structure. • The vent MUST NOT be connected to any other duct, vent or chimney. • DO NOT use sheet metal screws or other fastening devices which extend into the interior of the exhaust vent. • Provide an opening with a free area of at least 25 square inches for introduction of outside air into the dryer room. • See the sections for electrical connection information. 49-3000195 13