Haier QFD15ESSNWW Installation Instructions - Page 28

ENGLISH TROUBLESHOOTING TIPS Problem Dryer shakes or makes noise Clothes take too long to dry The Dry dryness level was chosen but load is still damp Control buttons not responding Dryer doesn't start No numbers displayed during cycle, only lights Possible Cause Some shaking/noise is normal. Dryer may be sitting unevenly. Improper or obstructed ducting Improper sorting Large loads of heavy fabrics (like beach towels) Controls improperly set Lint filter is full Blown fuses or tripped circuit breaker Overloading/combining loads Underloading Load consists of a mixture of heavy and light fabrics Lint filter is blocked Dry Sensor is dirty Controls accidentally put in service mode Controls accidentally put in lock mode Controls performed an incorrect operation Control panel is "asleep" Dryer is unplugged Fuse is blown/circuit breaker is tripped Dryer was accidentally paused when starting Delay Dry Dryer is continuously monitoring the amount of moisture in the clothes What To Do Move dryer to an even floor space, or adjust leveling legs as necessary until even. Check the Installation Instructions to make sure the dryer venting is correct. Make sure ducting is clean, free of kinks and unobstructed. Check to see if outside wall damper operates easily. Separate heavy items from lightweight items (generally, a well-sorted washer load is a well-sorted dryer load). Large, heavy fabrics contain more moisture and take longer to dry. Separate large, heavy fabrics into smaller loads to speed drying time. Match control settings to the load you are drying. Clean lint filter before every load. Replace fuses or reset circuit breakers. Since most dryers use 2 fuses/ breakers, make sure both are operating. Do not put more than one washer load in the dryer at a time. If you are drying only one or two items, add a few items to ensure proper tumbling. When combining heavy and light fabrics in a load, choose More Dry. Inspect and clean lint filter. Clean the sensor with a moist cloth. Press Start/Pause. Hold the Lock Control button for 3 seconds to unlock the dryer. Reset the in-house breaker. This is normal. Press Power to activate the control panel. Make sure the dryer plug is pushed completely into the outlet. Check the building's fuse/circuit breaker box and replace fuse or reset breaker. NOTE: Electric dryers use two fuses or breakers. If the light on the Start/Pause button is flashing, the dryer is paused. Press Start/Pause to restart the countdown. This is normal. When the dryer senses a low level of moisture in the load, the dryer will display the dry time remaining. 28 49-3000195