Haier QFD15ESSNWW Installation Instructions - Page 25

ENGLISH INSTALLATION INSTRUCTIONS INSTALLING THE STACK BRACKET KIT 1 INSTALL BRACKET TO WASHER A. Remove washer top cap screw from the rear left. Align left bracket holes with top cap screw hole on rear left of the unit and replace screw. NOTE: Leave screws loose so dryer hole alignment will be easier. B. Drive next screw through the bracket into the rear of the washer. C. Repeat the above steps with the right side. 2 INSTALL DRYER AND BRACKET ON DRYER (CONT.) C. Tighten the dryer bracket screws; then tighten all stacking kit screws. Long screws into brackets and dryer Washer Top Short screws into brackets and washer 2 INSTALL DRYER AND BRACKET ON DRYER WARNING Disconnect power before installing. Failure to do so could result in serious injury or death. WARNING - Excessive Weight Hazard Failure to do so may result in back or other injury, or property damage. • Use two or more people to install dryer. • Avoid tipping and rupture of utility services. • Dryer must be securely attached to the washer. • DO NOT place the washer on top of the dryer. A. Lift the dryer on top of the washer. Protect the washer control panel with cardboard or other protection. Be sure to lift the dryer high enough to clear the washer control panel. B. Align the holes in the bracket with the holes in the back of the dryer. Using a Phillips screwdriver, attach the 2 #8 x 1/2" tapping screws. 3 FINALIZE THE INSTALLATION CAUTION Do not push on the dryer once installed to top of the washer. Pushing on the dryer may result in pinched fingers. A. Refer to the washer Installation Instructions to complete the washer installation. B. Refer to the dryer Installation Instructions to complete the dryer installation. C. Carefully slide or walk the stacked washer and dryer into place. Use felt pads or other sliding device to assist moving and to protect flooring. Dryer Place hands here Place hands here 49-3000195 Washer 25