Haier QFD15ESSNWW Installation Instructions - Page 29
Problem, Possible Causes, What To
View all Haier QFD15ESSNWW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
ENGLISH TROUBLESHOOTING TIPS Problem Time Remaining jumped to a lower number Cannot make a selection and the dryer beeps twice Dryer is running but 00 is displayed in Time Remaining Clean Lint Filter (message) Dryer doesn't heat Inconsistent drying times Glow at the rear of the drum Clothes are still wet and dryer shut off after a short time Clothes are wrinkled Possible Causes The estimated time may change when a smaller load than usual is drying The dryness Level, Temp or option that you are trying to select is incompatible with the chosen dry cycle The Ext Tumble option was chosen Power button was activated Fuse is blown/circuit breaker is tripped; the dryer may tumble but not heat Type of load and drying conditions Type of load and drying conditions Heaters behind the drum The door was opened midcycle. The load was then removed from the dryer and a new load put in without selecting a new cycle Small load Load was already dry except for collars and waistbands Dryer is not level Overdrying Letting items sit in dryer after cycle ends Overloading This is normal. This is normal. What To Do This is normal. During extended tumbling, the time remaining is not displayed. The extended tumbling option lasts approximately 60 minutes. Press Start/Pause to begin a dry cycle and the message will disappear. Check the building's fuse/circuit breaker box and replace both fuses or reset both breakers. Your dryer may tumble if only one fuse is blown or one breaker tripped. The load size, types of fabric, wetness of clothes and the condition of the lint filter and/or air intake vent located on the front of the dryer will affect drying times. The load size, types of fabric, wetness of clothes and the length and condition of the exhaust system will affect drying times. This is normal. Under certain drying conditions and room ambient lighting, the glow of the heaters may be visible at the rear of the drum. A dry cycle must be reselected each time a new load is put in. When drying 3 items or less, choose Quick Dry or Time Dry. Choose Quick Dry or Time Dry to dry damp collars and waistbands. In the future, when drying a load with collars and waistbands, choose More Dry. Move dryer to an even floor space or adjust leveling legs as necessary until even. Select a shorter drying time. Remove items while they still hold a slight amount of moisture. Select a Less Dry or Damp setting. Remove items when cycle ends and fold or hang immediately, or use the Ext Tumble option. Separate large loads into smaller ones. 49-3000195 29