Hayward Variable Speed Pump Owners Manual - Page 20
Initial startup, Configuration Menu
View all Hayward Variable Speed Pump manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
6.5. Initial startup After plumbing and wiring are complete, the variable speed drive must be configured prior to use. When power is applied to the drive for the first time, the following informational screens are displayed. Screen Comments 1. Hayward EcoStar Pump SP3400VSP Pump SKU will be shown at the bottom of the screen. 2. Thursday 1:27p 1725rpm 380 Watts 3. Timer 1 timer will end at 11:45p Note: Speeds can be selected at this time to temporarily run the pump, however, it is recommended that the drive configuration and timers be set according to individual installation site requirements (see section 11 for more details). At this point, pressing the MENU button will select the Configuration Menu. 6.6. Configuration Menu Screen 1. Configuration Menu Locked Buttons Used Comments Press & hold < and > buttons for several seconds to unlock Configuration Menu 2. Configuration Menu press > to enter Use > to enter Configuration Menu 3. Use + / - to adjust, > go to next item 4. Time: Th 1:27PM +- Use + to change clock setting + change or > skip Use > if clock is correct 5. Set Day and Time Thursday 1:27p 6. Speed Selection rpm 7. MAX allowed speed 3450 (600-3450rpm) +- Adjust day/time setting Move to next selection, then to next menu item +- Select whether to display speed in rpm (Revolutions per Minute) or % of full speed Move to next menu item +- Set maximum running speed of pump Move to next menu item 8. MIN allowed speed 600 (600-3450rpm) +- Set minimum running speed of pump Move to next menu item Page 20 of 36 USE ONLY HAYWARD GENUINE REPLACEMENT PARTS EcoStar Variable Speed Pump IS3401VSP Rev-2