HP 2420 HP LaserJet 2400 Series - Software Technical Reference (External) - Page 143

HP traditional drivers Product image The bitmap image in the lower-right portion of the Paper tab represents the current physical configuration of the product and corresponds to its configuration data. It should look the same as the image that appears in the same location on the Configure tab in the printer Properties dialog. On the Paper tab, the product image contains hot spots where you can select a media source. When you use the mouse to move the pointer over a hot spot, the arrow reverts to a gloved hand. The current media source tray, whether selected from the drop-down menu or from a product image hot spot, is highlighted on the product image. The following points are worth noting: ■ The Automatically Select setting in the Source is: drop-down menu does not have a corresponding area to highlight in the product image. Selecting other settings in this menu highlights the corresponding part in the product image. ■ Selecting the area that represents a tray in the image always selects the corresponding tray in the Source is: option. Manual Feed in Tray 1, which is available from the Source is: drop-down menu, cannot be selected by selecting the image. ■ On the Paper tab, only source trays have product image hot spots and can be highlighted. Job Storage tab features You can store print jobs in the HP LaserJet 2410, 2420, and 2430 printer memory for printing at a later time. These job-storage features are described in the following sections. The Job Storage tab appears among the driver tabs only if Job Storage is enabled. To support jobstorage features for complex jobs, or if you often print complex graphics, print postscript (.PS) documents, or use many downloaded fonts, HP recommends that you install additional memory. Added memory also gives you more flexibility in supporting job storage features. A minimum total memory of 80 MB is required to use Job Storage features. After additional memory is installed, the driver must be configured to reflect the changes in the product. If bidirectional communication is enabled in your environment, the Update Now feature can be used to update the drivers. For more information, see the Configure tab features in this chapter. To configure the drivers manually after installing additional memory, follow these steps: 1 Click Start, select Settings, and then click Printers. 2 Right-click the product name, click Properties, and then click the Configure tab. 3 Under Other Options, click More.... 4 If additional memory has been installed, change the setting in the Total Memory: drop-down menu. If you select a minimum of 80 MB, this also selects the Job Storage Enabled check box. 5 Click OK to make the job-storage features available. NOTE To disable Job Storage, click Start, select Settings, and then click Printers. Rightclick the product name, click Properties, click the Configure tab, click More..., and then click to clear the Job Storage Enabled check box in the More Configuration Options box. When Job Storage is disabled, the Job Storage tab is not visible. HP traditional PCL 6 and PCL 5e driver features 127