HP 6120XG HP ProCurve Series 6120 Blade Switches Access Security Guide - Page 403
Messages Related to 802.1X Operation, Table 10-4., 1X Operating Messages
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 403 highlights
Configuring Port-Based and User-Based Access Control (802.1X) Messages Related to 802.1X Operation Messages Related to 802.1X Operation Table 10-4. 802.1X Operating Messages Message Meaning Port < port-list > is not an authenticator. The ports in the port list have not been enabled as 802.1X authenticators. Use this command to enable the ports as authenticators: ProCurve(config)# aaa port-access authenticator e 10 Port < port-list > is not a supplicant. Occurs when there is an attempt to change the supplicant configuration on a port that is not currently enabled as a supplicant. Enable the port as a supplicant and then make the desired supplicant configuration changes. Refer to "Enabling a Switch Port as a Supplicant" on page 10-49. No server(s) responding. This message can appear if you configured the switch for EAP-RADIUS or CHAP-RADIUS authentication, but the switch does not receive a response from a RADIUS server. Ensure that the switch is configured to access at least one RADIUS server. (Use show radius.) If you also see the message Can't reach RADIUS server < x.x.x.x >, try the suggestions listed for that message (page 5-53). LACP has been disabled on 802.1X port(s). To maintain security, LACP is not allowed on ports configured for 802.1X authenticator operation. If you configure port security on a port on which LACP (active or passive) is configured, the switch removes the LACP configuration, displays a notice that LACP is disabled on the port(s), and enables 802.1X on that port. Error configuring port < port-number >: Also, the switch will not allow you to configure LACP on a LACP and 802.1X cannot be run together. port on which port access (802.1X) is enabled. 10-73