HP 6120XG HP ProCurve Series 6120 Blade Switches Access Security Guide - Page 448
CLI: Viewing and Configuring Authorized IP Managers
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 448 highlights
Using Authorized IP Managers Defining Authorized Management Stations 2. Enter an Authorized Manager IP address here. 3. Use the default mask to allow access by one management device, or edit the mask to allow access by a block of management devices. See "Building IP Masks" on page 12-10. 4. Use the Space bar to select Manager or Operator access. 5. Press [Enter], then [S] (for Save) to configure the IP Authorized Manager entry. Applies only to access through Telnet, SNMPv1, and SNMPv2c. Refer to the note on page 12-3. Figure 12-2. Example of How To Add an Authorized Manager Entry (Continued) Editing or Deleting an Authorized Manager Entry. Go to the IP Managers List screen (figure 12-1), highlight the desired entry, and press [E] (for Edit) or [D] (for Delete). CLI: Viewing and Configuring Authorized IP Managers Authorized IP Managers Commands Used in This Section Command show ip authorized-managers ip authorized-managers mask Page below 12-7 12-8 12-8 Listing the Switch's Current Authorized IP Manager(s) Use the show ip authorized-managers command to list IP stations authorized to access the switch. For example: 12-6