HP 6120XG HP ProCurve Series 6120 Blade Switches IPv6 Configuration Guide - Page 113
timep dhcp, timep manual, Interval < 1 - 9999 > ], Syntax:., ipv6-addr
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
Note IPv6 Management Features SNTP and Timep ip timep manual < ipv6-addr > Enable Timep operation with a statically configured [ interval < 1 - 9999 >] IPv6 address for a Timep server. Optionally change the interval between time requests. no ip timep Disables Timep operation. To re-enable Timep, it is necessary to reconfigure either the DHCP or the static option. To use a global unicast IPv6 address to configure an IPv6 Timep server on the switch, the switch must be receiving advertisements from an IPv6 router on a VLAN configured on the switch. To use a link-local IPv6 address to configure an IPv6 Timep server on the switch, it is necessary to append %vlan followed (without spaces) by the VLAN ID of the VLAN on which the server address is available. The VLAN must be configured on the switch. For example: fe80::11:215%vlan10 Syntax:. ip timep dhcp [ interval < 1 - 9999 >] ip timep manual < ipv6-addr | ipv4-addr > [ interval < 1 - 9999 >] Used at the global config level to configure a Timep server address. Note: The switch allows one Timep server configuration. timep dhcp: Configures the switch to obtain the address of a Timep server from an IPv4 or IPv6 DHCP server. timep manual: Specifies static configuration of a Timep server address. < ipv6-addr >: Specifies the IPv6 address of an SNTP server. Refer to preceding Note. [ Interval < 1 - 9999 > ]: This optional setting specifies the interval in minutes between Timep requests. (Default: 720) For example, to configure a link-local Timep server address of: fe80::215:60ff:fe7a:adc0 where the address is on VLAN 10, configured on the switch, you would enter this command at the global config level, as shown below. 5-13