HP 7150 HP Photosmart 7150 printer - (English) Basic Guide - Page 11

load photo paper in the photo tray 3 Place a stack of paper into the IN tray. • Load the paper with the side to be printed facing down. The printer pulls the paper in, flips it over, and then prints on the paper; the finished document faces up in the OUT tray. • Always load paper in the portrait direction, with the shortest edge toward you. • Be careful not to use too much or too little paper. It may be difficult for the printer to pick up a sheet of paper when there are only one or two sheets in the IN tray. Check that the stack of paper contains several sheets but is no higher than the top of the paper length guide. See the specifications section of the HP Photosmart Printer Help for more information. • Use one type and size of paper at a time. Do not mix paper types or sizes in the IN tray. 4 Move the photo tray slider toward you until it stops. This disengages the photo tray. 5 Adjust the paper width guide and paper length guide to fit close to the edges of the paper without bending the paper. This helps the paper feed straight into the printer. 6 Lower the OUT tray. When you use the photo tray you can leave paper in the IN tray. If you run out of photo paper in the photo tray, the printer continues to print using paper from the IN tray. 1 Move the photo tray slider toward you until it stops. This disengages the photo tray. 2 Lift the photo tray cover. get started: paper information 7