HP 7150 HP Photosmart 7150 printer - (English) Basic Guide - Page 31

Problem (continued from previous page) Printing is very slow. The printer will not turn on. The Print light is blinking green. The Print light is blinking amber. The Print light is blinking red. Possible cause You may be printing in Reserve Mode. The printer enters Reserve Mode when one of the print cartridges is missing. The printer may have drawn too much power. The printer is plugged into a power strip and the power strip is turned off. The printer may be processing information. The printer needs attention. A fatal error has occurred. Solution Replace the missing print cartridge with a new one. Unplug the printer's power cord and wait approximately 10 seconds. Reconnect the power cord and press the POWER button to turn on the printer. Turn on the power strip. Be patient. The printer needs some time to finish processing the information. Try the following: 1 Check the computer monitor or camera LCD for instructions. 2 If this does not work, turn the printer off. Unplug the printer's power cord, wait one minute, then plug it in again. Turn the printer on. Try the following: 1 Turn the printer off. Unplug the printer's power cord, wait one minute, then plug it in again. Turn the printer on. 2 If this does not work, check www.hp.com or contact HP Support and Services. See the Software Setup & Product Support booklet that came with your printer for contact information. troubleshooting: printer problems 27