HP Color LaserJet Enterprise CP4020 Service Manual - Page 390
Cleaning Disk <x>% Complete, Card Slot File System Is Full
View all HP Color LaserJet Enterprise CP4020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 390 highlights
Table 3-14 Control-panel messages (continued) Description Recommended action CARD SLOT DEVICE FAILURE The specified device has failed. Press the OK button to clear. To clear press OK CARD SLOT FILE OPERATION FAILED To clear press OK A PJL file system command attempted to perform an illogical operation. Press the OK button to clear. CARD SLOT FILE SYSTEM IS FULL To clear press OK A PJL file system command could not store Press the OK button to clear. something on the file system because the file system was full. CARD SLOT IS WRITE PROTECTED To clear press OK The file system device is protected and no new files can be written to it. Press the OK button to clear. CARD SLOT NOT INITIALIZED This file-storage component must be initialized before use. Use the embedded Web server or HP Web Jetadmin to initialize the component. CHECKING PAPER PATH The product is checking for possible paper No action is necessary. jams. CHECKING PRINTER The product is conducting an internal test. No action is necessary. CHOSEN PERSONALITY NOT AVAILABLE To continue press OK A print job requested a product language (personality) that is not available for this product. The job will not print and will be cleared from memory. Print the job by using a printer driver for a different printer language, or add the requested language to the product (if possible). To see a list of available personalities, print a configuration page. (See Configuration page on page 307.) CLEANING DISK % COMPLETE Do not power off The product is cleaning the hard disk or a compact flash disk. Do not turn off. The product will automatically restart when cleaning is complete. Product functions are unavailable. CLEANING... The product is performing an automatic No action is necessary. cleaning cycle. Printing will continue after the cleaning is complete. CLEARING EVENT LOG This message is displayed while the event log No action is necessary. is cleared. The product will exit the menus once the event log has been cleared. CLEARING PAPER PATH The product is attempting to eject jammed paper. Check progress at the bottom of the display. CLOSE FRONT DOOR The front door of the product is open. 1. Close the door. 2. Run the switch test in the sensor monitor mode to verify that the front-door switch is functioning properly. 3. Reconnect connector J45 on the front door switch and connector J129 on the DC controller PCA. 4. Check the sensor flag on the front-door assembly. If it is damaged, replace the front-door assembly. See Front-door assembly on page 107. 358 Chapter 3 Solve problems ENWW