HP EliteBook 630 Maintenance and Service Guide - Page 49
Solid-state drive, Remove the Phillips M2.0 × 2.5 screw
View all HP EliteBook 630 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
2. Carefully disconnect the two antenna cables from the module (1). 3. Remove the Phillips M2.0 × 2.5 screw (2), and then remove the WLAN module (3). NOTE: The #1 white WLAN antenna cable connects to the WLAN module #1 Main terminal. The #2 black WLAN antenna cable connects to the WLAN module #1 Aux terminal. 4. If the WLAN antenna is not connected to the terminal on the WLAN module, install a protective sleeve on the antenna connector, as shown in the following illustration. Reverse this procedure to install the WLAN module. Solid-state drive To remove the M.2 solid-state drive, use this procedure and illustration. Solid-state drive 41
2.
Carefully disconnect the two antenna cables from the module
(1)
.
3.
Remove the Phillips M2.0 × 2.5 screw
(2)
, and then remove the WLAN module
(3)
.
NOTE:
The #1 white WLAN antenna cable connects to the WLAN module #1 Main terminal. The #2 black
WLAN antenna cable connects to the WLAN module #1 Aux terminal.
4.
If the WLAN antenna is not connected to the terminal on the WLAN module, install a protective sleeve on
the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WLAN module.
Solid-state drive
To remove the M.2 solid-state drive, use this procedure and illustration.
Solid-state drive
41