HP EliteDesk 800 G5 Maintenance and Service Guide - Page 47
Installing a 3.5-inch hard drive, If you are adding a second 3.5-inch hard drive
View all HP EliteDesk 800 G5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Installing a 3.5-inch hard drive NOTE: There are two 3.5-inch hard drive bays. The procedure for installing a 3.5-inch hard drive is the same for each drive bay. 1. Prepare the computer for disassembly (Preparation for disassembly on page 18). 2. Remove the access panel (Access panel on page 19). 3. Install mounting screws on the sides of the hard drive using standard 6-32 silver-and-blue mounting screws. NOTE: If replacing a 3.5-inch hard drive, transfer the mounting screws from the old hard drive to the new hard drive. If you are adding a second 3.5-inch hard drive, you can purchase extra mounting screws from HP. ● Install four silver-and-blue 6-32 mounting screws (two on each side of the drive). ● You can also install a 2.5-inch hard drive into a 3.5-inch drive bay using an adapter bracket similar to the example shown below. - Slide the 2.5-inch drive into the 3.5-inch adapter bracket. Drives 37