HP Evo n180 Maintenance and Service Guide Compaq Evo N180 Series - Page 108
Removing the Charger Board, Remove the shield
View all HP Evo n180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
Removal and Replacement Procedures 2. Remove the three PM2.0 × 5.5 screws 1 that secure the charger board to the base enclosure (Figure 5-27). 3. Lift the back 2 and middle 3 of the board to disconnect it from the system board. 4. Lift the board straight up and remove it from the base enclosure 4. 5. Remove the shield 5. ✎ The charger board shield is included in the Hardware Kit (spare part number 253937-001). Figure 5-27. Removing the Charger Board Reverse the above procedure to install the charger board. 5-36 Maintenance and Service Guide
5–36
Maintenance and Service Guide
Removal and Replacement Procedures
2.
Remove the three PM2.0 × 5.5 screws
1
that secure the
charger board to the base enclosure (Figure 5-27).
3.
Lift the back
2
and middle
3
of the board to disconnect it
from the system board.
4.
Lift the board straight up and remove it from the base
enclosure
4
.
5.
Remove the shield
5
.
✎
The charger board shield is included in the Hardware Kit (spare
part number 253937-001).
Figure 5-27. Removing the Charger Board
Reverse the above procedure to install the charger board.