HP Evo n180 Maintenance and Service Guide Compaq Evo N180 Series - Page 93
Removing the Heat Sink Screws, Lift the right side of the heat sink
View all HP Evo n180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Removal and Replacement Procedures 4. Remove the four PM2.0 × 5.5 screws 1 that secure the heat sink to the base enclosure (Figure 5-15). ✎ The screws should be removed and replaced in the 1, 2, 3, 4 sequence as stamped on the heat sink. 5. Lift the right side of the heat sink 2 and slide it to the right at an angle until the left side of the heat sink is clear of the base enclosure. Figure 5-15. Removing the Heat Sink Screws Maintenance and Service Guide 5-21
Removal and Replacement Procedures
Maintenance and Service Guide
5–21
4.
Remove the four PM2.0 × 5.5 screws
1
that secure the heat
sink to the base enclosure (Figure 5-15).
✎
The screws should be removed and replaced in the 1, 2, 3, 4
sequence as stamped on the heat sink.
5.
Lift the right side of the heat sink
2
and slide it to the right at
an angle until the left side of the heat sink is clear of the base
enclosure.
Figure 5-15. Removing the Heat Sink Screws