HP Evo n180 Maintenance and Service Guide Compaq Evo N180 Series - Page 80
Removing the Hard Drive, connector from the system board.
View all HP Evo n180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Removal and Replacement Procedures 6. Remove the hard drive by following these steps: a. Remove the battery pack (Section 5.3). b. Remove the optical drive. c. Remove the two PM2.0 × 5.5 screws 1 that secure the hard drive bracket to the base enclosure (Figure 5-5). d. Slide the hard drive forward 2 to unseat the hard drive connector from the system board. e. Lift the front edge of the hard drive bracket 3 until it clears the base enclosure and slide the hard drive bracket out of the hard drive bay. Figure 5-5. Removing the Hard Drive Reverse the above procedure to install the hard drive. 5-8 Maintenance and Service Guide
5–8
Maintenance and Service Guide
Removal and Replacement Procedures
6.
Remove the hard drive by following these steps:
a.
Remove the battery pack (Section 5.3).
b.
Remove the optical drive.
c.
Remove the two PM2.0 × 5.5 screws
1
that secure the
hard drive bracket to the base enclosure (Figure 5-5).
d.
Slide the hard drive forward
2
to unseat the hard drive
connector from the system board.
e.
Lift the front edge of the hard drive bracket
3
until it
clears the base enclosure and slide the hard drive bracket
out of the hard drive bay.
Figure 5-5. Removing the Hard Drive
Reverse the above procedure to install the hard drive.