HP Kayak XU 03xx HP Kayak XU Series 03xx, Familiarization guide - Page 34

Complete the Questionnaire to Check Your Understanding

Get HP Kayak XU 03xx PDF manuals and user guides View all HP Kayak XU 03xx manuals
Add to My Manuals
Save this manual to your list of manuals

Page 34 highlights

Complete the Questionnaire to Check Your Understanding Complete the Questionnaire to Check Your Understanding Circle each letter that corresponds to a correct answer. (There may be more than one correct answer to each question). 1 Can a 256 MB registered ECC memory module be mixed with a non-buffered ECC SDRAM memory? a Yes, it can. However, the 256 MB module must be installed in Slot 1. b No, it cannot. Registered and non-buffered memory modules are not compatible. 2 Can a maximum of 512 MB of non-buffered ECC SDRAM memory modules be installed on HP Kayak XA-s, XU Series 0301 and 0303, and XW Series U3 and W3 PC Workstations? a Yes, by installing 4 x 128 MB memory modules. b No. On the HP Kayak XA-s, there are only three DIMM sockets available. 3 For models with the HP FastRAID2 I/O Subsystem, can you boot from the Windows NT CD-ROM when replacing a disk drive? a Yes, because Windows NT is capable of finding a new hard disk drive. b No, because the new hard drive will not be found. 4 Where can you find all of the HP FastRAID software (ArrayConfig, drivers and CI/O Manager) and Operating System Installation notes (such as Windows NT 4.0)? a HP Kayak XU/XW PC Workstation Drivers CD-ROM. b HP's WWW site. c Netscape Communicator CD-ROM. 5 To run the MaxiLife diagnostics program, does the computer need to be powered on? a No, it doesn't. The HP MaxiLife is always running and continuously monitors the state of the LCD buttons. b Yes, it does. This can be easily checked, because the LCD status panel will be blank. 34

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
34
Complete the Questionnaire to Check Your Understanding
Complete the Questionnaire
to Check Your Understanding
Circle each letter that corresponds to a correct answer. (There may be more
than one correct answer to each question).
1
Can a 256 MB registered ECC memory module be mixed with a
non-buffered ECC SDRAM memory?
a
Yes, it can. However, the 256 MB module must be installed in
Slot 1.
b
No, it cannot. Registered and non-buffered memory modules are
not compatible.
2
Can a maximum of 512 MB of non-buffered ECC SDRAM memory
modules be installed on HP Kayak XA-s, XU Series 0301 and 0303,
and XW Series U3 and W3 PC Workstations?
a
Yes, by installing 4 x 128 MB memory modules.
b
No. On the HP Kayak XA-s, there are only three DIMM sockets
available.
3
For models with the HP FastRAID2 I/O Subsystem, can you boot
from the Windows NT CD-ROM when replacing a disk drive?
a
Yes, because Windows NT is capable of finding a new hard disk
drive.
b
No, because the new hard drive will not be found.
4
Where can you find all of the HP FastRAID software (ArrayConfig,
drivers and CI/O Manager) and Operating System Installation
notes (such as Windows NT 4.0)?
a
HP Kayak XU/XW PC Workstation Drivers CD-ROM.
b
HP’s WWW site.
c
Netscape Communicator CD-ROM.
5
To run the MaxiLife diagnostics program, does the computer
need to be powered on?
a
No, it doesn’t. The HP MaxiLife is always running and continuously
monitors the state of the LCD buttons.
b
Yes, it does. This can be easily checked, because the LCD status
panel will be blank.