HP Kayak XU 03xx HP Kayak XU Series 03xx, Familiarization guide - Page 6

HP Kayak PC Workstation Overview Component XA-s (Minitower models) XU (Series 0301 and 0303)1 XW (Series U3 and W3) SCSI Connectors Video Controllers Accessory Board Slots Communications For SCSI models only. None Ultra-Wide 16-bit internal SCSI connector for both external and internal drives (up to 40 MB per second), plus two internal narrow SCSI connectors. Subsystem with HP FastRAID Port. All models are equipped with a Matrox Productiva G100 AGP graphics controller board. There is a total of 8 MB SDRAM of installed memory which cannot be upgraded. XU Series 0301 models are equipped with a Matrox® Millennium II AGP graphics controller board. There is 8 MB of installed WRAM which can be upgraded to 12 or 16 MB. XU Series 0303 models are equipped with a Matrox® Millennium II G200 graphics controller board. There is 8 MB of installed SGRAM which can be upgraded to 12 or 16 MB. XW Series U3 models are equipped with an AccelEclipse II AGP graphics controller board. There is 32 MB of installed video memory (not upgradeable). XW Series W3 models are equipped with an HP VISUALIZE Fx4 graphics controller board. There is 18 MB of installed video memory. The Texture module upgrade supplies 16 MB of additional texture memory. All models have 6 slots: 1 AGP, 3 PCI, 1 ISA, 1 combination ISA/PC. Support for WOL2 compatible LAN boards. 1 AGP slot used for the Video Adapter. Note: The XA-s are not delivered with an installed LAN board. I PCI slot used for the LAN/Ultra-Wide SCSI board with RPO capability. 1 AGP slot used for the Video Adapter. 1 RAID/PCI slot. Some models are equipped with the Adaptec® ARO-1130 PCI RAIDport™ adapter new generation (FastRAID2). All models have 2 USB (A, B) connectors, 2 serial ports, 1 parallel port CD-ROM Drive All models include a 32X speed IDE CD-ROM Audio All models have an integrated 16-bit hi-fi audio processor with music synthesizer and mixer HP MaxiLife Utility (available on all models) Hardware monitoring utility that monitors system components (for example: if you are unable to get the system and display working properly). When an error is detected it is displayed on the dedicated LCD located on the front panel. Power Supply Input voltage: 100-127, 200-240V ~ Input frequency: 45/66Hz Maximum output power: 260W continuous 1. The series type (0301 or 0303) is marked on the Support label, found on the back of the workstation (right or left-hand side of the box). Refer to page 27 for more information about identifying a video board on an HP Kayak XU PC Workstation. 2. WOL = Wake On LAN 6