HP LH4r HP Netserver LT 6000r Installation Guide - Page 65
Installing an Accessory Board in Slot 1
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Chapter 6 Installing Additional Boards 17. Use the respective NOS to ensure that the correct PCI board software drivers are loaded, and verify its correct operation. 18. Restore the NetServer to normal operation. Installing an Accessory Board in Slot 1 This section explains how to install a PCI accessory board in Slot 1 via the installed accessory board tray. This tray is used specifically for installing a board in Slot 1 when the NetServer is mounted in a rack. Accessory Board Tray Guidelines Use the following guidelines when installing accessory boards in the accessory board tray: l Install only half-size accessory boards in the tray when the server is mounted in a rack. l Full-size accessory boards should be installed in the tray when the server is not installed in a rack. l Recommended accessory boards for use in the accessory board tray are listed in Table 6-1. Table 6-1. Recommended Accessory Boards for Use in Accessory Board Tray *See explanation of Cases following table. Half-Size PCI Accessory Board D2140 1Si DAC D5013 LAN PCI NIC D5025 Ultra Wide SCSI Adapter D6977 Fiber Channel Bus Adapter D8602A Fiber Channel Bus Adapter D6028 RMC Board Full-Size PCI Accessory Board D5955 3Si DAC D9161 4Si DAC D9351 4Si DAC Case 1 Yes Yes Yes Yes Yes No No No No Case 2 Case 3 Yes Yes** Yes Yes** Yes Yes** Yes Yes** Yes Yes** No Yes** Yes Yes*/** No Yes*/** No Yes*/** 57