HP LaserJet 3052 HP LaserJet 3050/3052/3055/3390/3392 All-in-One User Guide - Page 255
Network: How do I?, Set up the all-in-one and use it on the network - windows 10 driver
View all HP LaserJet 3052 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 255 highlights
Network: How do I? Use this section to answer network questions. Set up the all-in-one and use it on the network Hewlett-Packard recommends that you use the HP software installer on the CDs that came with the all-in-one to set up printer drivers for the following network setups. To configure a network port-connected all-in-one configuration (direct mode or peer-to-peer printing) In this configuration, the all-in-one is connected directly to the network, and all computers on the network print directly to the all-in-one. NOTE This mode is the recommended network configuration for the all-in-one. 1. Connect the all-in-one directly to the network by inserting a network cable into the all-in-one network port. 2. At the all-in-one, use the control panel to print a Configuration page. See Configuration page. 3. Insert the all-in-one CD into your computer. If you have already set up your all-in-one, click Install Software to start the software installer. If the software installer does not start, navigate to the hpsetup.exe file on the CD and double-click the file. 4. Click Install HP LaserJet 3390/3392 all-in-one Software. 5. On the Welcome screen, click Next. 6. On the Installer updates screen, click Yes to search for installer updates on the Web. 7. For Windows 2000, on the Installation Options screen, choose the installation option. HewlettPackard recommends a typical installation, if your system supports it. 8. On the License Agreement screen, read the license agreement, indicate that you accept the terms, and then click Next. 9. For Windows 2000, on the HP Extended Capabilities screen, choose whether you want extended capabilities, and then click Next. 10. On the Destination Folder screen, choose the destination folder, and then click Next. 11. On the Ready to Install screen, click Next to begin installation. NOTE If you want to change your settings, instead of clicking Next, click Back to return to previous screens, and then change the settings. 12. On the Connection Type screen, select Through the network, and then click Next. 13. On the Identify Printer screen, identify the all-in-one either by searching or by specifying a hardware or IP address, which is listed on the Configuration page you printed earlier. In most cases an IP address is assigned, but you can change it if you want by clicking Specify the printer by Address on the Identify Printer screen. Click Next. 14. Allow the installation process to complete. ENWW Network: How do I? 237