HP LaserJet Pro M1130 Service Manual - Page 141

Table 2-3 Control-panel light patterns (continued) Light status Error code State of the product Ready light is blinking slowly. The product is in low power mode. Action No action is required. Attention light is blinking. E0 E1 E2 E4 E5 H0 H1 The attention and toner lights are E3 blinking. Paper is jammed in the product. Clear the jam. The input tray is empty. Load the tray. A door is open Verify that the print-cartridge door is fully closed. The product memory is full The job is too complex for the product to print. Simplify the job, or divide it into multiple files. The product did not pick up paper from You might need to clean or replace the the tray. pickup roller. The product is in manual-feed mode. Load the correct paper type and size into the input tray. The product is processing a manual duplex job. Load the pages into the input tray to print the second sides. The print cartridge is missing or is not Install the print cartridge. installed correctly. The toner light is on. Attention light is blinking, and ready light is on. ENWW The print cartridge has reached the end of its estimated useful life. When the supply has reached this condition, the HP Premium Protection warranty for that supply has ended. You do not need to replace the print cartridge at this time unless print quality is no longer acceptable. The product has experienced a If the recovery is successful, the continual error from which it will recover product continues to the processing on its own. data state and completes the job. If the recovery is unsuccessful, the product continues to the continuable error state. Try removing any paper from the paper path and turning the product power off, and then on again. Tools for troubleshooting 121