HP LaserJet Pro M1130 Service Manual - Page 143
Interpret control-panel messages (HP LaserJet Professional M1210 MFP series only)
View all HP LaserJet Pro M1130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
Interpret control-panel messages (HP LaserJet Professional M1210 MFP series only) Control-panel message types Alert and warning messages appear temporarily and might require you to acknowledge the message by pressing the OK button to resume or by pressing the Cancel button to cancel the job. With certain warnings, the job might not complete or the print quality might be affected. If the alert or warning message is related to printing and the auto-continue feature is on, the product will attempt to resume the printing job after the warning has appeared for 10 seconds without acknowledgement. Critical error messages can indicate some kind of failure. Turning off and then turning on the power might fix the problem. If a critical error persists, the product might require service. Control-panel messages Control panel message 22 Scanner Error 50.X Fuser Error Turn off then on 52 Scanner Error Turn off then on Description The product has experienced an internal hardware error. The product has experienced an internal hardware error. The product has experienced a scanner error. Recommended action 1. Check all of the FFC connections. 2. Verify that the CIS scanner-carriage can move along the track in the scanner assembly, and that the scanner motor can rotate. 3. If the error persists, replace the FFC cable (cable-scan model). 4. If the error persists, replace the scanner motor or the CIS scanner-carriage. See CIS scanner motor, gears, and scanner light bar on page 58 or CIS scannercarriage assembly on page 56. 5. If the error persists, replace the formatter. See Formatter PCA on page 68. 1. Turn off the power by using the power switch, and then wait at least 30 seconds. 2. If a surge protector is being used, remove it. Plug the product directly into the wall socket. 3. Turn on the power and wait for the product to initialize. If the error persists, replace the fuser. See Fuser on page 79. Turn off the power by using the power switch, wait at least 30 seconds, and then turn on the power and wait for the product to initialize. If a surge protector is being used, remove it. Plug the product directly into the wall socket. Use the power switch to turn the product on. If the error persists, replace the scanner assembly. See Scanner assembly on page 30. ENWW Tools for troubleshooting 123