HP LaserJet Pro M1130 Service Manual - Page 58
Rear cover, Remove the rear cover
View all HP LaserJet Pro M1130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Rear cover Before proceeding, remove the following components: ● Paper-delivery tray. See Paper-delivery tray (output bin extension) on page 21. ● Left cover. See Left cover on page 22. ● Right cover. See Right cover on page 25. ● Front cover. See Front cover on page 28. ● Scanner assembly. See Scanner assembly on page 30. ● Cartridge door . See Cartridge door on page 33. ● Top cover. See Top cover on page 36. Remove the rear cover 1. Remove four screws (callout 1) and release two tabs (callout 2). NOTE: One screw has a tooth washer. Make sure this screw is installed in the correct position when the cover is reinstalled. Figure 1-54 Remove the rear cover (1 of 2) 1 2 38 Chapter 1 Removal and replacement ENWW
Rear cover
Before proceeding, remove the following components:
●
Paper-delivery tray. See
Paper-delivery tray (output bin extension)
on page
21
.
●
Left cover. See
Left cover
on page
22
.
●
Right cover. See
Right cover
on page
25
.
●
Front cover. See
Front cover
on page
28
.
●
Scanner assembly. See
Scanner assembly
on page
30
.
●
Cartridge door . See
Cartridge door
on page
33
.
●
Top cover. See
Top cover
on page
36
.
Remove the rear cover
1.
Remove four screws (callout 1) and release two tabs (callout 2).
NOTE:
One screw has a tooth washer. Make sure this screw is installed in the correct position
when the cover is reinstalled.
Figure 1-54
Remove the rear cover (1 of 2)
1
2
38
Chapter 1
Removal and replacement
ENWW