HP Latex 3200 Site Preparation Guide - Page 27
Shipment arrival preparation
View all HP Latex 3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
3 Shipment arrival preparation Unloading area A suitable unloading area will need to be designated that will be easily accessible to the delivery truck. This will require sufficient space to unload the large crate in which your printer is shipped. When planning this area, consider the following: ● Height and width of entrance to unloading area ● Ramps used to access the unloading area ● Height and size of unloading dock (if applicable) The unloading area must have enough space to unload the accessory crate (HP Latex 3800 only) from each side (front and rear) with the forklift, or to rotate the crate and access each side with the forklift correctly. Route from unloading site to installation site The route between the unloading area of the printer and the installation site, including any corridors and doorways through which the printer must be transported, is important to proper site preparation and must be planned before the arrival of the printer. This pathway must be clear when the printer arrives. Regarding ground floor room access, transport of the bulky printer components requires: Doorway, ceiling and corridor specifications Minimum doorway width Minimum ceiling height Minimum corridor width Minimum corridor width for a 90° turn Printer 1.85 m (73 in) 2 m (79 in) 1.85 m (73 in) 3.9 m (154 in) Crate 2 m (79 in) 2.5 m (98 in) 2 m (79 in) 3.9 m (154 in) WARNING! After being removed from the crate, the printer can be moved up or down a ramp of no more than 5% inclination. TIP: Decide when you will remove the printer from the crate. It is recommended that the shipping crate be unpacked as close as possible to the printer's final destination. Usually, the printer is removed from the crate before moving it to the installation site. Disassembling the crate requires an electric screwdriver that must be plugged into a power outlet, so make sure that a power outlet is available near the site where you plan to disassemble the crate. ENWW Unloading area 23