HP N6350 HP Scanjet N6350 Getting Started Guide - Page 8
Connect the TMA/ADF cable, Connect the power supply, Connect the Ethernet cable - scanjet scanner
UPC - 884420551898
View all HP N6350 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Chapter 1 Connect the TMA/ADF cable Connect the TMA/ADF cable from the lid to the scanner base. Connect the power supply 1. Plug the cable that is attached to the power supply into the power connector on the back of the scanner. 2. Plug the small end of the AC cable into the back of the power supply. 3. Plug the other end of the AC cable into a power outlet or surge protector. 4. To turn on the scanner, press the Power button on the scanner control panel. Connect the Ethernet cable To connect the scanner to a host computer on an existing network, complete the following steps. CAUTION: If you are installing in a Windows environment, do not connect the scanner to the network until prompted to do so during the software install (see "Install the software" on page 2). 1. Press the Power button to turn off the scanner. 2. Disconnect the USB cable from the scanner if it is connected. 4 HP Scanjet N6350