HP OMEN 15-ce100 Maintenance and Service Guide - Page 56
System support brackets, Disconnect the power connector cable from the system board
![]() |
View all HP OMEN 15-ce100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
System support brackets NOTE: The system support brackets are not spared. IMPORTANT: Make special note of each screw and screw lock size and location during removal and replacement Before removing the system support brackets, follow these steps: 1. Shut down the computer. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer. 4. Remove the battery (see Battery on page 36), and then remove the following components: ▲ Hinge covers (see Hinge covers on page 45). Remove the system support brackets: 1. Disconnect the power connector cable from the system board (1). 2. Remove the power connector cable from the routing path and clips (2). NOTE: The power connector cable is routed through the left side system support bracket. 3. Remove the seven Phillips PM2.0×5.7 and two Phillips PM2.4×7.2 screws (3) that secure the brackets to the computer. 46 Chapter 6 Removal and replacement procedures for authorized service provider parts
![](/manual_guide/products/hewlettpackard-omen-15ce000-maintenance-service-guide-6d555dd/56.png)