HP Pavilion 15-bc200 Maintenance and Service Guide - Page 68

Display assembly, and then remove the tape the holding

Get HP Pavilion 15-bc200 PDF manuals and user guides View all HP Pavilion 15-bc200 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 68 highlights

Display assembly Before removing the display assembly, follow these steps: 1. Prepare the computer for disassembly (Preparation for disassembly on page 36). 2. Remove the base enclosure. 3. Disconnect the cable from the battery (see Battery on page 38). Remove and disassemble the display panel: 1. Disconnect the WLAN antenna cables from the WLAN module (1), and then remove the tape the holding the antennas in place (2). 2. Disconnect the display cable from the system board ZIF connector (3), and then release the cable from the routing channels (4). 60 Chapter 5 Removal and replacement procedures for authorized service provider parts

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
Display assembly
Before removing the display assembly, follow these steps:
1.
Prepare the computer for disassembly (
Preparation for disassembly
on page
36
).
2.
Remove the base enclosure.
3.
Disconnect the cable from the battery (see
Battery
on page
38
).
Remove and disassemble the display panel:
1.
Disconnect the WLAN antenna cables from the WLAN module
(1)
, and then remove the tape the holding
the antennas in place
(2)
.
2.
Disconnect the display cable from the system board ZIF connector
(3)
, and then release the cable from
the routing channels
(4)
.
60
Chapter 5
Removal and replacement procedures for authorized service provider parts