HP Pavilion PC 14-dv1000 Maintenance and Service Guide - Page 45
Remove the Phillips M2.0 × 2.5 screw, sleeve on the antenna connector
![]() |
View all HP Pavilion PC 14-dv1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Remove the WLAN module: 1. Carefully disconnect the antenna cables from the module (1). 2. Remove the Phillips M2.0 × 2.5 screw (2), and then remove the WLAN module (3). NOTE: Models have either one or two WLAN antennas. On models with two antennas, the #1 white WLAN antenna cable connects to the WLAN module #1 Main terminal. The #2 black WLAN antenna cable connects to the WLAN module #1 Aux terminal. 3. If the WLAN antenna is not connected to the terminal on the WLAN module, you must install a protective sleeve on the antenna connector, as shown in the following illustration. Reverse this procedure to install the WLAN module. Component replacement procedures 37
![](/manual_guide/products/hewlettpackard-pavilion-pc-14dv1000-maintenance-service-guide-eabe47e/45.png)
Remove the WLAN module:
1.
Carefully disconnect the antenna cables from the module
(1)
.
2.
Remove the Phillips M2.0 × 2.5 screw
(2)
, and then remove the WLAN module
(3)
.
NOTE:
Models have either one or two WLAN antennas. On models with two antennas, the #1 white
WLAN antenna cable connects to the WLAN module #1 Main terminal. The #2 black WLAN antenna cable
connects to the WLAN module #1 Aux terminal.
3.
If the WLAN antenna is not connected to the terminal on the WLAN module, you must install a protective
sleeve on the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WLAN module.
Component replacement procedures
37