HP ProLiant MicroServer Gen8 HP ProLiant MicroServer Gen8 Maintenance and Serv - Page 27
Install the chassis cover, Connect the server to the network. Do one of the following
View all HP ProLiant MicroServer Gen8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
7. Slide the chassis cover toward the rear panel, and then lift it to remove it from the chassis. Install the chassis cover 1. Align the installation markers on the chassis cover with those located on the front edge of the chassis, and then slide the chassis cover back onto the server. 2. Tighten the rear thumbscrews to secure the chassis cover in place. 3. Connect the peripheral devices to the server. 4. If a Kensington security cable was removed, connect it to the rear panel. See the security cable documentation for instructions. 5. Connect the server to the network. Do one of the following: o Connect the Ethernet cable. o Connect the server to the switch. 6. Connect the power cord to the server. Removal and replacement procedures 27
Removal and replacement procedures
27
7.
Slide the chassis cover toward the rear panel, and then lift it to remove it from the chassis.
Install the chassis cover
1.
Align the installation markers on the chassis cover with those located on the front edge of the chassis,
and then slide the chassis cover back onto the server.
2.
Tighten the rear thumbscrews to secure the chassis cover in place.
3.
Connect the peripheral devices to the server.
4.
If a Kensington security cable was removed, connect it to the rear panel. See the security cable
documentation for instructions.
5.
Connect the server to the network. Do one of the following:
o
Connect the Ethernet cable.
o
Connect the server to the switch.
6.
Connect the power cord to the server.