HP ProLiant MicroServer Gen8 HP ProLiant MicroServer Gen8 Maintenance and Serv - Page 30
Install the system board assembly, Drive carrier
View all HP ProLiant MicroServer Gen8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Install the system board assembly 1. Slide the system board assembly into the chassis. 2. Connect all cables disconnected from the system board and/or expansion board. Drive carrier CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with either a component or a blank. To remove the component: 1. Open the front bezel (on page 24). 2. Remove the drive carrier. To replace the component, slide the component into the bay until it clicks. Removal and replacement procedures 30
Removal and replacement procedures
30
Install the system board assembly
1.
Slide the system board assembly into the chassis.
2.
Connect all cables disconnected from the system board and/or expansion board.
Drive carrier
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1.
Open the front bezel (on page
24
).
2.
Remove the drive carrier.
To replace the component, slide the component into the bay until it clicks.